can you suggest good traning institute in instrumentation ? (in automation, or designing)

5 Answers  

---

IF TX SHOWS SLOW RESPONSE, WHILE A CLOSE LOOP AND WHEN WE PUT THE CONTROLLER ON MANUAL THE PROBLEM RECTIFIED, SO WE CAN SAY THE PROBLEM IS IN

1 Answers   IFFCO,

---

i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....

0 Answers  

---

what is easiest way to read STL language in PLC?

0 Answers   LB Industries,

---

what is the difference between magnetic flow meter and mass flowmeter

0 Answers  

---

---

Isometric drawings are generated during _________________ phase of a project

0 Answers  

---

Where we r using split range and ratio controller?

1 Answers   EID Parry,

---

In electronic board one fuse(rating 230v,100ma)showing 2.5 ohms with multimeter,then the fuse is healthy or not.

4 Answers  

---

if RTD damage in plant, how we know?

5 Answers   Reliance,

---

Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....

0 Answers  

---

PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear

0 Answers   MSL, SRAAC,

---

calculate the rane of level use of this values, h=3 meter density=0.9 , whats the rang?

2 Answers  

---