i get noise in radio when i switch on tubelight, the radio is working in dc ada

i get noise in radio when i switch on tubelight, the radio
is working in dc adapter.but when in battery , raio dont get
noise.is there anyway to implement any circuit so that the
noise never comes.i tried lots of capacitor. no way to
prevent it.

Question Posted / binoy

3 Answers
4996 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

i get noise in radio when i switch on tubelight, the radio is working in dc adapter.but when in bat..

Answer / suman bisws

plug dc adapter into another room ..this may help to get rid of ur problems...or try to replace the choke of the tubelight..

Is This Answer Correct ?

0 Yes

0 No

i get noise in radio when i switch on tubelight, the radio is working in dc adapter.but when in bat..

Answer / reshma

due to interference in air

Is This Answer Correct ?

0 Yes

0 No

i get noise in radio when i switch on tubelight, the radio is working in dc adapter.but when in bat..

Answer / rajesh

Use a low pass filter with cut off 50Hz

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electronics Communications Interview Questions

What are the differences between voltage and current controlled devices?

0 Answers

Susan made a block with small cubes of 8 cubic cm volume to make a block ,3 small cubes long, 9 small cubes wide and 5 small cubes deep. She realizes that she has used more small cubes than she really needed. She realized that she could have glued a fewer number of cubes together to lock like a block with same dimensions, if it were made hollow. What is the minimum number of cubes that she needs to make the block? a) 114 b) 135 c) 21 d) 71

3 Answers TCS,

8085 micrprocessor architecture?

1 Answers CTS, HCL,

what is the importance of clock frequency in microprocessor?

3 Answers

what is an operational amplifier?

0 Answers

In the case of baseband signaling, the received waveforms are already in a pulse-like form. Why then, is a demodulator (receiving filter) needed to recover the pulse waveform?

0 Answers

What do you mean by the term "open" in OSI model?

6 Answers

How the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?

0 Answers

when the generator running trip by earth current even though engine all so shut down the problem showing gcs waring and emergency trip there after starting always gcs locked out what is the problem [this is cummins qsk 23 electronic controle module governer

0 Answers

What are the losses that occur in a thyristor during working conditions?

0 Answers

Why is modification of signal required for transmission Over channel?

5 Answers

convert d flip flop to jk flip flop using mux

0 Answers ABC,

For more Electronics Communications Interview Questions Click Here