Interested to Buy Any Domain ? << Click Here >> for more details...
why do you add the load short circuit impedance when
considering short circuit amperage. It seems that you should
only consider supply.
If you need to consider loads and you don't know what loads
are to be added , what would be a good sub-transient
reactance rating for the loads?
- 0 Answers
- 1745 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
where to use CT and PT?
In EHV tranm. The conductors are …….. a) Cu roads b) Cu bars with Si c) Cu tube with Si plate
2 Answers Engineers India Limited,
How to calculate the sag of OPGW during stringing???
how can we minimize the off load losses of a distribution transformer which is required to be energized 24x7 ?? capacity of the T/F is 1250 KVA and off load losses are around 2.0 KW.. can we use capacitor bank at the secondary of such a T/F to overcome off load losses? please elaborate briefly...thanks
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
Write down the name of 2 lady Bir Pratin of Bangladesh
what is EP panel and AHS panel
What is acsr cable and where we use it?
What is the possible cause for failure of lightning arrestors in outdoor substation under normal condition
what factors to needed while selecting a MCB and MCCB
How would you relate your key competencies to this position?
what is meant by trivector meter?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
