Anyone any idea about LTE and GSM internetworking.
Is it like GSM is used for backbone comm in LTE??
- 4 Answers
- 13994 Views
- Ericsson, NSN, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / kajjal bhardwaj
lte is stand for long term evolution.it is a 4th generation
technology which promises a much higher air interface data
rate(over 100 mbps)to user while reduces the cost per bit 4
wireles service providers.
gsm is 2g technolgy..........
in gsm tdm nd fdm is used and in lte ofdm & all ip techniques
r used.
yes gsm is used back bone comm in lte
| Is This Answer Correct ? | 26 Yes | 4 No |
Answer / sanil
Long Term Evolution (LTE) is the next step from 3G/WCDMA &
HSPA for many already on the GSM technology curve but also
for others too, such as CDMA operators. This new radio
access technology will be optimized to deliver very fast
data speeds of up to 100Mb/s downlink and 50Mb/s uplink
(peak rates).
Designed to be backwards-compatible with GSM and HSPA, LTE
incorporates Multiple In Multiple Out (MIMO) in combination
with Orthogonal Frequency Division Multiple Access (OFDMA)
in the downlink and Single Carrier FDMA in the uplink to
provide high levels of spectral efficiency and end user data
rates exceeding 100 Mbps, coupled with major improvements in
capacity and reductions in latency. LTE will support channel
bandwidths from 1.25 MHz to 20 MHz and both FDD and TDD
operation.
Although both LTE and WiMAX use the OFDMA air interface, LTE
has the advantage of being backwards compatible with
existing GSM and HSPA networks, enabling mobile operators
deploying LTE to continue to provide a seamless service
across LTE and existing deployed networks.
Several major mobile operators, including some running CDMA
networks today, have indicated they will adopt LTE in the
next few years. Japanese mobile operator NTT DOCOMO has said
that it is aiming to launch a commercial LTE network by the
end of 2009, while in the U.S., the largest CDMA operator,
Verizon Wireless, is currently trialing LTE with a view to
launching a commercial LTE service in 2010.
LTE- Advanced
LTE-Advanced extends the technological principles behind LTE
into a further step change in data rates. Incorporating
higher order MIMO (4x4 and beyond) and allowing multiple
carriers to be bonded together into a single stream, target
peak data rates of 1Gbps have been set.
LTE-Advanced also intends to use a number of further
innovations including the ability to use non-contiguous
frequency ranges, with the intent that this will alleviate
frequency range issues in an increasingly crowded spectrum,
self back-hauling base station and full incorporation of
Femto cells using Self-Organising Network techniques.
LTE-Advanced will be 3GPP’s technology as a candidate for
the ITU-R IMT-Advanced process, which is intended to
identify ‘4G’ technologies.
| Is This Answer Correct ? | 16 Yes | 1 No |
Answer / vrushali
One more imformation that, 802.16 m standard is going to
release which is a new highend version of current WIMAX
which is believed to provide data rates upto 16 Gbps in down
link.
By the way please explain SCFDMA if possible.
| Is This Answer Correct ? | 5 Yes | 0 No |
Answer / vrushali
Ok.. I know that but i want to know exactly like in future,
do we require to replace the Base Station in case of LTE or
Wimax. As already we have Base Station installed all over
the country.
As it would increase the overall cost of implementation also.
| Is This Answer Correct ? | 3 Yes | 2 No |
Explain the cycling frequency hopping in gsm technology?
What is synthesised frequency hopping in gsm technology?
What is the difference between sqi and rxqual?
What is the ssi?
Do you know what is gsm technology?
Do you know what is frequency re-use?
Define GSM.
0 Answers Mahatma Gandhi University,
Describe GSM with one of advantage?
Explain cycling frequency hopping?
What is gos in gsm technology?
Do you know which type of connector we use at the end of gsm antenna?
Explain the tdd in gsm technology?
WiFi Protocols 
