question related 2 soal car:
Working under a bright light bulb or in direct sunlight,
experiment with the angle of light hitting the solar
panels. What angle gives you the fastest rotation of the
wheels?
How would you modify this car to make the wheels turn
faster?
How would you modify this design to make a car that could
carry or pull a heavier load?
How could you modify this design so that your car could run
for short periods in complete darkness or low light
situations?
The amount of solar energy absorbed from the source will not
depends upon how much brighter the source but depends on the
intensity of radiation of generation and angle of projection
on to the surface of solar panels.
Capability of absorption of radiation depends upon the
length of radius from source to solar surface and would be
maximum at 90 deg angle as reflection from the surface will
be minimum.
I would be know that in a solar car the torque for the
wheel is supplied from an electric motor. The source for the
electric motor is from the batteries which can be charged by
solar energy. wheels can run faster as u give higher voltage
to the motor. So the speed of car depends on your motor
capacity and the distance you could travel depends on your
battery bank charging capacity.
If you increase the capacity of motor you will have
higher speed as well as you can modify the design to make
your car that could carry heavy loads.
By increasing the size of the battery bank (in sens
capacity to store energy will be increased) you can run the
car for short periods in complete darkness or low light
situations.
| Is This Answer Correct ? | 4 Yes | 0 No |
What is dtsi? Why it is used in motor bikes?
pls any one send me the last 5 years rrb QP - hari.devarajan@gmail.com
In si units, one ton of refrigeration is equal to ?
What do you call the clearing of air inside cylinder after combustion?
What are the requirements of a good fuel?
One unit of btu is how many joules?
1.What is the difference between safety valve and relief valve?
Which is not present in CI engines?
what roal of balancing disk in boiler high preesure feed pump.
sir,i want the papers of section engineers asking by all the rrb's in exam.plz give the ideas or way for better preperation
Why stop ratio valve is necessary before gas control valve in GE gas turbines.
Kaplan turbine is used for _______head
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)