when & where we say that here communication electronics
gets involve ?
Difference b/w communication electronics, power
electronics, digital electronics, discrete electronics,
analogue electronics & Mechatronics ?
Where these are used & can be used ?
Answers were Sorted based on User's Feedback
Answer / nitin bishoriya
As now our more emphasis is on saving power and bandwidth
in communication,so we used digital
communication.Communication electronics includes the use of
elctronics devices and system for transmission,analysing
and amplification of signal.
Power elctronics as the name suggest deal with large power
that is not in case of ordinary device like diode and
transistor.For high power application we use
Thyristor,Triac,Diac.
Unlike three state in transistor i.e.
cutoff,active,saturation. In digital electronics there are
only two states on(cutoff) and off(saturation).This is
called digital as we got output in two forms only either
high or low.Various elements of logic family are
CMOS,TTL,RTL,DTL,HTL.
Is This Answer Correct ? | 5 Yes | 0 No |
Answer / sikendra singh
communiccation is basically means of correct transferring
of the referred signal by transmitter to receiver end & if
this communication is done by using electronics circuits,
then it is referred as electronic communication...differnt
type of modulations can be realise by using electronics
circuit ,this can be an example for the electronics
commmunication
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / gayathri
mechtronics is d name refers to mechanical ,electrical and elcronics. in robotics....
Is This Answer Correct ? | 0 Yes | 0 No |
Explain why 440 volts instead of 660 volts in 3 phases of supply system?
What is a multiplexer?
HI FRANDS , ANY ONE SUGGEST ME THE INTERVIEW QUESTION OF NHPC
What is PLC ? How it is useful in automations ?
What type of questions are asked in Tetra pak onlinr test
How can I understand electronic/electrical panel wiring & drawing?
What happens when an ammeter is connected across the circuit?
How many GDA exists for a group ?
Why 440 volts instead of 660 volts in 3 phases of supply system?
what do you use instead of the place of transistor and mosfet can you achieve the result without using transistor and mosfet
What are the applications of op-amps?
why is the plastic dip ic package most widely used?