what is the purpose of reheating the fuel in gas turbine

Categories >> Engineering >> Mechanical Engineering
Suggest New Category

Question Posted / kumar

5 Answers
10105 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is the purpose of reheating the fuel in gas turbine..

Answer / manish ag

to increases the efficiency or we can say effectiveness of
turbine.in that it utilies heat given by exhaust gas

Is This Answer Correct ?

9 Yes

2 No

what is the purpose of reheating the fuel in gas turbine..

Answer / hameedwahab

Purpose of reheating the fuel in gas turbine: When reheating the Fuel, it looses the viscosity so that it can be fully atomized, to get complete Combustion.
The Cold fuel will lead to Incomplete combustion and leave the un-burned fuel accumulation. This will be highly dangerous as it can get self Ignited and will lead to sudden Explosion.

Is This Answer Correct ?

0 Yes

0 No

what is the purpose of reheating the fuel in gas turbine..

Answer / kumar

Hi manish

can explain briefly how reheating can increase the
efficiency of the gas turbine?

Is This Answer Correct ?

1 Yes

2 No

what is the purpose of reheating the fuel in gas turbine..

Answer / narendra

increasing the eficiency bcoz while we do reheat the fuel
it's particles devided into fine so for that less heat
reqired for the combustion the fuel.

Is This Answer Correct ?

0 Yes

1 No

what is the purpose of reheating the fuel in gas turbine..

Answer / harish

Reheating is generally used in gas turbines in order to
increase the efficiency of the turbine . Not only reheating
inter cooling is also another process in order to increase
the efficiency of the gas turbine

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Mechanical Engineering Interview Questions

I've been running into situations where a relief valve is being used to protect a regulator. Is this common? And, is this a proper use of a relief valve?

0 Answers CDI,

what is the fuction of asstt. rigman drilling

0 Answers ONGC,

Why in screw & centrifugal compressor using rolor bearing

3 Answers Johnson Controls,

why we express the unit of torque in Nm.even though it can be expressed as Joule ( J )?

10 Answers BARC,

what is the diffrence betwen primary pumps and secondary pumps in aircoditioning field

0 Answers Carrier,

What is mean effective press?

2 Answers

How to check temperature controller?

0 Answers

What is the difference between hard water and soft water ?

1 Answers

What is the formula for heat loss in a pipe?

0 Answers

What is the difference between tube and pipe?

0 Answers

Low water in boiler drum is unsafe because it may result in overheating of water tubes in furnace. Why it is unsafe to have high water condition in boiler drum ?

0 Answers

• Why did you leave your last job?

1 Answers Petro Star Mount,

For more Mechanical Engineering Interview Questions Click Here