Answer / saravanan

Bearing is machine a element,used for supporting the
rotating parts by both axial and radial loads

types

ball
roller

Answer / dhiren

mainly two types of bearing
1.Friction bearing
2.Antifriction bearing

Because in above answer no place for journal bearing

Answer / pankaj singh

bearing is a machin element which support another moving
element.it also permit the relative motion between the
contect surface of the member while carring the load.
types of bearing depend's on following:-
1) depend upon direction of load to be supported :-
a) readial bearings b) thrust bearing
2) depand upon the nature of contect :-
a) sliding bearing b) rolling bearing

Answer / narendra

bearing is a part of machine in which the both axial &
radial loads are managed. also it is used in rotating parts.

Answer / ajit maurya

Bearing is machine arotating parts by both axial and radial loads element,used for supporting the

mainly two types of bearing
1.Friction bearing
2.Antifriction bearing

Answer / lokesh kanojia

bearing is a machine element which ensures relative motion between the parts...which can take both axial and radial load on the shaft
there are two tyes of bearng viz
1-sliding friction
2-anti friction

Answer / n venkat

Bearing is a machine element which is use to rotate a wheel smoothly by axial and redial load

How cavitation can be eliminated by pump?

1 Answers  

Match the following A. Manas I. Hangul B. Dachigam II. Elephant C. Mudumalai III. Tiger D. Kaziranga IV. Rhinoceros

1 Answers   RRB,

You have to design a machine component. For what type of failure (ductile or brittle) you will design?

9 Answers   DRDO,

Hiii.. i have applied for steel plant management trainee 2010 exam for stream mechanical... the pattern of the exam has changed.. a preliminary exam which consists of the engineering basics... can any one suggest any book for this... kindly respond to this...

0 Answers  

function of fly wheel

15 Answers   APGenco, Power Grid, RTPP,

what is the diffrence between Torque and Power ( layman Idea)?

0 Answers   BARC,

What are the causes of failure of boiler tubes ?

0 Answers  

what is the job responsilties of Sr. engineer in QA/QC deptt.

0 Answers  

What is higher IMP or BHR

0 Answers  

What do you mean by the term thread size please explain what does 0.125 inch stand for in 0.125 inch npt thread?

0 Answers  

bel question

0 Answers  

What is insulation?

2 Answers