Answer / kanth

dc is continuous flow of current so it doesnt leave our body
where as in ac current becomes to zero then goes to maximum
value

Answer / vinay

DC is a Unidirectional current it is only magnitude but No
direction, But AC is Magnitude Direction changes
periodically. Ex; Ac supply goes peak of its maximum
voltage and again it comes to zero.

Answer / chandini

DC is more dangerous than ac because DC is unidirectional
current which have magnitude and flows in one direction.But
AC changes its direction and magnitude periodically.AC goes
to maximum & comes to zero.Its wave form is sinosodialy.

Answer / mohan

AC supply having positive half cycle & negative half
cycle,Where as DC don't have.

Answer / dinesh kadam

Wether it is DC or AC Only value of current going through
body paralises the Muscles & burns the nerons in our Body.
If we campare this danger with Lunar Distance which is
356400kms for DC then danger because of the another one is
356000kms.
Do not consider that AC goes to Zero value, because the
reflex action of muscles is 0.15 to 0.30 sec & transmitting
reflexes through neuron is depending upon dynamic &
kinamatic signals through axons & neurons is 0.05 to 0.08
Sec. and AC reaches its zero value in 0.02 sec.
SO it make no difference.

Answer / surendra kumar bairwa

AT THE SAME VOLTAGE ,DC IS NOT CHANGES W.R.T. TIME SO THE DC
IS DANGER &IN CASE OF AC CHANGES ALTERNATE W.R.T. TIME, IT
MEANS THE POLERITY OF CURR. +VE TO 0 -VE.SO AC GIVES SHOCK.

Answer / a . k . mehta

For heart and lunga mustle the frequency of a.c . i.e.50hz.is extreme high and so respiration 'breathing stops causing death. While d.c does not have frequency and gives shock at very high voltage.

Answer / ram

ac is more harm than dc because it has peak current of sqrt(2) times of dc(ie RMS) value. shock is due to current flow only .

what is the importance of earthing system on the generators big capacity and small?

0 Answers  

Define settling time.

0 Answers  

what are the type of transformer?

4 Answers  

why 120 devided with pole and speed multiplication to determine frequency

1 Answers  

dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?

0 Answers  

how to determine kilowatts (real power) is used in energy meter? is it apparent power effect the disk rotation?

1 Answers  

HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?

0 Answers  

hi i have applied for lic of india south cenrtal zonal ,hyd. i didnt get hall ticket till now.let me know how can i get form internet

0 Answers  

What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage

0 Answers   Indeco,

what are the types of towers in HT transmission

2 Answers  

where AVR is connected in power plant.

7 Answers   ABB, Saudi Red Bricks,

I want to know all basics of electrical engineering

0 Answers   RRB,