Interested to Buy Any Domain ? << Click Here >> for more details...
2. What are the valid ways to segment a LAN? (Choose all
that apply)
A. Repeater
B. Bridge
C. Switch
D. Router
- 2 Answers
- 6860 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / kapilasdhir
Answer: B, C, D
Repeaters do not segment the network, but rather extend the
distance a LAN can run
| Is This Answer Correct ? | 7 Yes | 4 No |
Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX
friends i have some problem in the acess list plz help me out. purbi sinha. 1 what is the diffrence b/w inbound and out bound access list 2 what is main diffrence betwwen standred acesslist and extended access list 3 where should i keep stnadred access list and exatended access list i mean at which interface and why? 4 why wild card masking is used 5 what is switch febric in switching plz help me out i am litle bit confuse
What we called 64 bit mac-address in ipv6?
Identify the purpose of ARP? A.) Avoiding routing loops B.) Determining a workstation's IP address C.) Sending a directed broadcast D.) Determining a workstation's MAC address
Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco
You have powered on a new router and you want to create an initial configuration. Which mode should you use? A. copy mode B. user mode C. setup mode D. startup mode
What type of switching creates variable latency through the switch? A.) Cut-Through B.) Inverted C.) Layer 4 D.) Multiplexed E.) Store and Forward
Which command line statement determines the number of seconds a dialup connection can wait without any traffic before the router hangs up? A.) dialler max-time B.) dialler timeout C.) dialer idle-timeout D.) dialer hang-up E.) disconnect-timer
Which layer are called upper layer?
What is HDLC?
Of the following switching types, which one has the highest latency? A.) Cut-through B.) None C.) Store-and-forward D.) Fragment Free
Does a bridge divides a network into smaller segments?
CCNA 
