why bevelling is done in an orifice ?

Question Posted / abhinav prateek

4 Answers
10682 Views
ABB, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why bevelling is done in an orifice ?..

Answer / naveed t p

i think it prevents votex formation, increase recovery
factor of pressure after vena contracta since there
pressure is minimum & velocity maximum. This helps the flow
to be recovered better than if it was sharp edge.

Is This Answer Correct ?

13 Yes

1 No

why bevelling is done in an orifice ?..

Answer / anup ramteke

no 2 answer is correct but rather than recovery of pressure
it provides smooth recovery of fluid flow thus preventing
the turbulence in the flow and making it laminar.

Is This Answer Correct ?

6 Yes

0 No

why bevelling is done in an orifice ?..

Answer / instru

The orifice is beveled on the downstream edge, in accordance
to AGA report #3. The purpose of the bevel is to reduce the
width of the throat to the "e" dimension.

Is This Answer Correct ?

3 Yes

0 No

why bevelling is done in an orifice ?..

Answer / jose

to cause a vortex

Is This Answer Correct ?

2 Yes

8 No

Post New Answer

More Instrumentation Interview Questions

who to convert dc to ac

7 Answers ONGC,

anybody having Qatar Petroleum questions for instrument Technician offshore ....please send me

0 Answers

units of pressure,flow, level,temperature? principle of pressure gauge? calibration of pressure tx., level tx., temperature tx.flow tx.? description of two wire ,three wire and four wire R.T.D.? WHAT IS INPUT AND OUTPUT OF TX.? WHAT IS INPUT AND OUTPUT OF R.T.D. AND THERMOCOUPLE? WHAT IS HOT LOOP AND COLD LOOP? WHAT IS INPUT AND OUT PUT AND OUTPUT OF D.C.S. AND P.L.C.? PRINCIPLE AND WORKING OF HART? WHAT IS PNP AND NPN PROXY? CALIBRATION OF PRESSURE ,LEVEL ,FLOW SWITCH? DESCRIPTION OF FIELDBUS FOUNDATION? WORKING OF SOV.?

2 Answers

i am confusing about differential pressure transmitter as i seen so many DPTs in different ranges how can we calculate level and flow with mmh20 plz tel me

1 Answers

i want interview questions about PROCESS CONTROL INSTRUMENTATION , SENSORS AND TRANSDUCERS IF ANY BADY KNOW ABOUT THAT PLEASE SEND TO MY MAIL karumudi1003@gmail.com

8 Answers Honeywell, Reliance,

Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..

0 Answers

What unit is used for measuring comp. outlet flow. it is CFM, M3/hr or NM3/hr. ?

5 Answers Jk Tyres,

I am pujita completed Electronics and Instrumentation Engineering.As a fresher i am going to attend the interviews.Could anybody guide the topics/questions covered mostly in interviews.

11 Answers

what is difference between E/P positioner and I/P positioner. Why E/P fixed in below actuator and why I/P fixed in other place

1 Answers

CAN WE CALIBRATE LEVEL TRANSMITTER USING HART COMMUNICATOR WHEN WATER LEVEL IS PRESENT IN THE BOILER SHELL?

4 Answers Chemin, Emerson,

What should we do when Fisher Fieldvue DVC2000 give some out put air at 4mA bt at that i need no out put

1 Answers

WHAT IS THE DIFF BETWEEN FREQUENCY AND INTENSITY?HOW IT WORKS IN FLAME SCANNER ?

1 Answers

For more Instrumentation Interview Questions Click Here