Why do we use FM for sound and AM for video in TV
transmisssion?
Answers were Sorted based on User's Feedback
Answer / guest
In case of FM,we have to vary the frequency according to
the modulating frequency and amplitude remains costant
thats why to eliminate the losses due to the amplitude is
very small that is required for clear sound.
In second case the amplitude of the incoming signal varies
and the frequency remains constant that is required for
sharp and clear picture.
Is This Answer Correct ? | 39 Yes | 13 No |
Answer / falak
FM provides a better scheme as compared to AM as far as performance is concerned (especially in non-linear channels).
the video signal needs very high bandwidth to cover minute details which would turn to be impracticable to be commercialized. therefore AM is used for video part.
the bandwidth needed for sound signals is much much lesser than its video part so FM is affordable for sound signals.
therefore FM is used for sound signals.
Is This Answer Correct ? | 13 Yes | 8 No |
Answer / reddy
basically eye is not sensitive to detect some noises in
video. but ears can detect highly sensitive to noise in
sound......
so FM has constant amplitude which is less senstive to
distortion is used in sound transmission. and AM is used in
video transmission
Is This Answer Correct ? | 7 Yes | 6 No |
Answer / vinit92
fm is used in sound because every person have a different
voice quality and different voice frequency .and in fm
frequency change with respect to the information .every
person have a different voice frequency so we are using fm
in sound so we can get natural frequency effect in sound
........
but in video we are using am because in video
color,contrasts can be easily adjusted in am and video are
making on frame so frame can be easily adjusted on am so we
are using am in video ...
Is This Answer Correct ? | 3 Yes | 5 No |
Answer / ashish
in FM the amplitude ramains constant.it is a property of the
noise disturbance that it affects the amplitude of the
signal.so at the recieving end if we found the amplitude
variation in FM wave then it will be due to the noise hence
it can be eliminated by using the appropriate filter without
the loss of information.hence FM is used for sound signals.
Is This Answer Correct ? | 6 Yes | 17 No |
hey, i am confused with ece n cse..both attract me the same..just that wich one has higher placements n pay pakages n which one has higher scope after doing mba??..reply urgently..
How many satellites are required to cover the earth?
which type of code is human code?
what is the difference between tcp and udp
what is setup time and hold time for a flip flop??
Telecom BSS related ques: For cascaded 1800 BTS with master 900 BTS,if 900 master BTS is down for its own equipment fault,cascaded slave 1800 BTS gets down/stop carrying traffic without any fault as BCCH and other controllong channels are in master 900 BTS.Is there any technology/system to turn the slave 1800 BTS to a single 1800 BTS autometcally when 900 master BTS is down for its own equipment fault???It is possible to make the slave 1800 BTS single live BTS manually.But I want to know the autometic system/process.if there is any....if not available, how can we generate the system??
3 Answers Ericsson, Grameen Phone, Nokia, TATA, Telecom,
equation for pid controller?
why is the name op-amp?
Draw the current Vs time graph for an inductor connected to a d.c. source. How will you measure power of a transmissioon line? Tell all the steps alongwith the components used in power generation. Which law governs the induced emf?
Define negative frequency?
how a choke of tubelight can be used to increse reciving power of antina?
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?