how dc ct works?

Question Posted / rahul

3 Answers
6239 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

how dc ct works?..

there is no CT to sense DC current

but it can be sensed by using two sets of rectifier units
placing one input to primary side of transformer and the
other in secondary side of the transformer.

but this is too expensive

Is This Answer Correct ?

1 Yes

5 No

how dc ct works?..

Answer / sp

for measuring current on dc ckt. A shunt connected in the
ckt, drop of mv volt measured and shown accordingly.
2mv -10amp
4mv -20amp

Is This Answer Correct ?

0 Yes

6 No

how dc ct works?..

Answer / vikramsena_reddys

A direct current transformer in which the primary consists
of an elongated strip of superconductive material, across
the ends of which is applied a direct current potential.
Parallel and closely spaced to the primary is positioned a
transformer secondary consisting of a thin strip of
magnetoresistive material.

Is This Answer Correct ?

0 Yes

10 No

Post New Answer

More Electrical Engineering Interview Questions

If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive

0 Answers

Q. calculate the value of the resistor to be connected in series with a 100W; 230V lamp so that the wattage of the lamp is reduced to 35W

8 Answers

Dear All, If we have 8No. 11kV cables running underground that are required to supply 20MW to a new development. What is the sustained current in Amps? Please advise.

1 Answers

define transient state &steady state

1 Answers

State the methods of improving power factor?

0 Answers

in pf lagging means current decrease by increasing voltage is correct or not ? reason ?

3 Answers

I have a 600VA numeriv digital UPS for computer only. It holds for 15 minutes only. but i am try to using home CFL Light I cant using UPS 2 or 3 secound automatic off .but computer ok how to change this is in to ups ?

1 Answers

what is the role of MPU in DG set

1 Answers Weltech Engineering,

what is the use of neutral displacement relay

1 Answers OCL,

how to test an MCB

2 Answers

Why we are measured insulation resistance applied through DC Voltage?

3 Answers

if a number of plc s are there then how many modbus to be used

0 Answers

For more Electrical Engineering Interview Questions Click Here