Answer / anoop kumar singh

Yes sir

i am anoop kumar singh
from delhi,post code 110018
mo no 09990639304

my father his retarmant in hindalco industries Ltd.
renukoot sonbhadra,post code 231217,
father name- mangru singh
alumuniyam plant clarephication,
E-code:-9100

what are the applications where bearing should not be used though it can be used(economy may be 1 of the reason)

0 Answers   IIT,

---

How can we find out the weight of metal sheet with the help of its dimensions.

8 Answers  

---

Locate nozzle in a turbocharger

0 Answers   RRB,

---

What is heat exchanger?

4 Answers  

---

sir i have to face an interview for marine trainee engineer on 15 sept tell me some related questions which r genrally asked...

0 Answers   Shell,

---

resent profession and what would you define as your career objectives

0 Answers  

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

what is the thickness tolerances up to 32 mm

0 Answers  

---

dear friends pls explain me what is meant by positive seal in solenoid operated valve

0 Answers   Essar,

---

Why do we use compressor in pumps for pumping water through borewells? Submersible pump is enough then why do we go for this method?

4 Answers  

---

Explain the nuclear reactor.

0 Answers  

---

how a disel engine works in generator? explain with labelled diagram?

2 Answers  

---