Answer / guest

To the Destination host

What is a function of a reliable transport layer connection? A. route selection B. acknowledgements C. session checkpoints D. system authentication

2 Answers  

---

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30

2 Answers  

---

What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.

2 Answers  

---

When setting up a WAN network, everything outside of the Demarc is not owned by the customer. Which of the following are not owned by the customer? A.) The T1 line. B.) LAN C.) The Router D.) DTE E.) PC's F.) CO

1 Answers  

---

---

What are the advantages of lan switching?

0 Answers  

---

What is the regional Telco office called, where the customers local loop terminates? A.) Demarc B.) DTE C.) DCE D.) CO E.) CPE

1 Answers  

---

How do you set the encapsulation type to PPP for an interface? A.) encap ppp B.) ppp encapsulation C.) encapsulation ppp D.) encapsulation ppp enable E.) ppp enable encapsulation

2 Answers  

---

Eight stations connected to separate 10 Mobs pods on a Layer 2 switch will give each station how many Mobs of bandwidth? A. 1.25 B. 4 C. 16 D. 10 E. 80

1 Answers  

---

thnx jitender...its me shridh...m working for SG ltd..the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected?? plz tel me jitender how to resolve ths problem? as u sd loop in switch is the primary cause of ths....i wanna know how to resolve it...thnx for ur replys jitender sinha.

2 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains

1 Answers  

---

What does the ping response & mean? * A: unreachable * B: congestion * C: user interrupt * D: unknown packet type * E: lifetime exceeded

6 Answers  

---