what are the alignment methods for any two turbine shafts
and formulae
Answers were Sorted based on User's Feedback
Answer / devanesan
Alignment Correction is doing as per the TIR value. the
correction value will depending on the Length of the Rotor
Support(correction point) and Diameter of the coupling.
one more method is by using graph sheet. it is not using
in india.
| Is This Answer Correct ? | 3 Yes | 0 No |
WHY DO DEAD BODIES SAIL ON WATER WHERE AS A HUMAN BEING GET DROWNED?
what is level of documentations for a iso 9001 certified company.
what are da different process to make gear
In order to increase efficiency and reduce co emissions and other emissions, clear coal technologies are receiving major attention. What are these ?
How to decide the thickness of sheet metal while designing the bracket?
Why tampering to be done?
please provide me the calculation for the thickness of duplex stainless steel pipeline thickness used in process industry ( Water). The details are given below. Diameter : 3" and 4" Thickness : 3.91mm, SCH40 Operating pressure : 62 bar Operating Temp : 35 degree ASME31.3
what is bms system and how to work it
What is daught, what kind of draught used in boiler chimney
I am requiering interview questions regarding Close Ferro Crome Furnaces
I have applied the post Junior Engineer-iii(c&w)in R.R.B Guwahati recently . what type of question i have to practice and which book ?. can i get any model question paper?
What is meant by indirect contact heat exchanger?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)