How can you keep our seawater used for heat rejection clean before entering our heat exchangers?

0 Answers  

---

ENGINEERING MECHANIC - EXAMPLE 15.3 : A biochemical trolley of mass 15 kg is towing a trailer of mass 5 kg along a straight horizontal pathway. The trailer and the trolley are connected by a light inextensible tow-bar. The engine of the trolley exerts a driving force of magnitude 100 N. The trailer and the trolley experience resistances of magnitude 10 N and 30 N respectively. (a) Form 2 equations with unknowns T and a, that represents the equilibrium for the 2 systems of the trolley and trailer. (b) Solve the simultaneous equations from the 2 equations that are obtained in part (a) of this question. T is the tension of the tow-bar and a is the acceleration.

1 Answers  

---

How much experience you are having in commercial software for protein design?

0 Answers   Aliens Group,

---

Explain what are some good uses of low-grade steam at 12 atm and 1920c?

0 Answers  

---

i am a prefinal year student of polymer engineering .could you please send the latest question papers regarding entrace exam.

0 Answers   IOCL,

---

---

white rust formation over zinc plated and yellow passivated fasteners during CED painting. WHY?

0 Answers   Wheels India,

---

How can I remove/decrease TDS from sewage waste water? At the moment it is 900gm/l. What is recommended TDS level to dispose sewage water in sea?

2 Answers   OGDCL,

---

On what basis are materials to be crushed evaluated apart from size?

0 Answers  

---

Three solid objects of the same material and of equal mass – a sphere, a cylinder (length = diameter) and a cube – are at 5000C initially. These are dropped in a quenching bath containing a large volume of cooling oil each attaining the bath temperature eventually. The time required for 90% change of temperature is smallest for a) cube b) cylinder c) sphere d) equal for all the three whyyyyyyy???????

3 Answers   GATE,

---

PROCESS DESIGN - EXAMPLE 21.3 : According to a heuristic of chemical engineering plant design, assume a pressure difference dP = 4 psi for each 10-ft rise in elevation. A pump is needed to pump liquid from a storage tank at a lower elevation to a heating tank at a higher elevation with the elevation difference of 60 ft. (a) Find the pressure loss due to such elevation. (b) If the required minimum inlet pressure to the heating tank is 9 psi, with 1 control valve is installed between pump and heating tank, what is the dP minimum required for the control valve and the entrance to the heating tank when the heuristic mentions that at least 10 psi is required for the control valve? (c) The pressure at the inlet of the pump is 8 psi and the flowrate of the liquid produces pressure head of 50 psi. What is the total pressure produced by the pump? (d) Assume a pipeline dP of 2 psi / 100 ft for liquid flow in a pipe according to heuristic, what is the approximate maximum length of the pipe in ft that can be installed between the pump and the heating tank?

1 Answers  

---

What is a common source of error in determining the percent spent caustic in refinery applications?

0 Answers  

---

What parameters should be considered while selecting type of filter?

4 Answers   Nocil,

---