Why are using 4ma to 20ma for signal transfer. Why not 0 to 20ma?
No Answer is Posted For this Question
Be the First to Post Answer
In order to find out stack fault of a three input nand gate how many necessary input vectors are needed ?
How the cellular phone is working?
GET-2013 exam is going to be held on which day(tentatively).
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?
What are the advantages of single phase bridge converter over single phase mid-point converter?
Explain radio environment in building.
What is its magnitude for ge and si?
What do you mean by a grounded load?
Explain what kind of negative feedback is present in a noninverting op-amp.
Hi i am going to attend the interview for BHEL. can you please help out in knowing about the area of preparation. I am apprearing for supervisor trainee post. i have done diploma + B.tech. suggest answer of question that don't you think that you are overqualified for this job. thanks rahul
plz send me previous question paper of RRB section Engineer- Electronics ,erpdayal@gmail.com
What is conductance? How is it measured?