What are 10base2 ethernet lans?
No Answer is Posted For this Question
Be the First to Post Answer
What purpose does aging serve in a link state protocol?
What will you do if ur IOS in coorrupt/deleted/Wrong Type/No IOS image ?
Based upon the 1st octet rule identify the range for a Class A address? A.) 1 - 126 B.) 192 - 223 C.) 128 - 191 D.) 1 - 191
What is difference between switch & hub?
What are some standards supported by the Presentation layer?
Write out a config to permit only the below MAC address to pass traffic through a port on your switch. mac-address 0005.1b00.5b58
i have donE B.E. IN COMPUTER SCIENCE AND THEN CCNA CERTIFICATOIN PLEASW LET ME KNOW IF ANY COMPANIES R HIRING FRESHERS PLEASE REPLY ON MY EMAIL ID karnailthakur@gmail.com
plz send me cisco contact no india?
hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku
what is difference between subnet-mask and wildcard mask?
What will happen in OSPF, While a new highet priority DR joining in already running area.That area already having DR and BDR.
"arpa" is used by the Cisco IOS for which encapsulation types? A. Ethernet_II B. Ethernet_802.3 C. Ethernet_802.2 D. Ethernet_SNAP