What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II

1 Answers  

---

Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active

1 Answers  

---

What is the Broadcast MAC Address?

3 Answers   Avaya, Cisco,

---

please name some routed protocol.

1 Answers  

---

When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?

0 Answers  

---

Can you explain encapsulating, carrier and passenger protocol?

0 Answers   CCIE,

---

Which of the following are examples of the Network Layer? A.) Token Ring B.) LLC C.) SQL D.) IP E.) TCP F.) IPX

3 Answers  

---

When setting up a WAN network, everything outside of the Demarc is not owned by the customer. Which of the following are not owned by the customer? A.) The T1 line. B.) LAN C.) The Router D.) DTE E.) PC's F.) CO

1 Answers  

---

Identify the type of hardware required to connect a Token ring network to an Ethernet network? A.) Repeater B.) TR-Enet C.) Router D.) Token Ring to Ethernet translation hub

1 Answers  

---

What information can you get from CDP info: (choose all that apply) A.) Hardware platform B.) One address per protocol C.) Software platform D.) Hostname E.) The same info as show version F.) Incoming/outgoing port

1 Answers  

---

What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.

1 Answers  

---

In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physcial interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay

2 Answers  

---