Answer / guest

Answer: E

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1

3 Answers   Cisco,

---

can we configure multiple as on single router using eigrp

1 Answers   IBM,

---

what is router?

9 Answers   IBM,

---

Explain why is udp lease favored when compared to tcp?

0 Answers  

---

What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message

1 Answers  

---

Identify the definition of demarcation? A.) Date in which the WAN service contract expires B.) Cabling which extends from the WAN service provider to the customer C.) Division of responsibility, where the CPE ends and the local loop begins D.) Equipment which is located at the customer premises

2 Answers  

---

Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  

---

In regards to TCP/IP, which class of address allows for the fewest valid Internet hosts? A.) D B.) E C.) Classes are not used in TCP/IP. D.) B E.) C F.) A

1 Answers  

---

The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments

2 Answers  

---

What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---

Which of the following are solutions to the problems encountered with Distance-Vector routing? A.) Defining a Maximum B.) Poison Reverse C.) Triggered Updates D.) Shortest path first algorithm. E.) Split Horizon

1 Answers  

---

plz send me cisco contact no india?

0 Answers   3i Infotech, Cisco,

---