Define logical topology.
No Answer is Posted For this Question
Be the First to Post Answer
Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay
What do you use the Aux port for? A.) Console B.) Terminal editing C.) Modem D.) Backup logging
When we use interface mode?
What is the function of DDR on Cisco routers? A. DDR is dial--on-demand routing. It provides a continuous LAN only connection. B. DDR is dial-on-demand routing. It provides routing for high volume traffic. C. DDR is dial--on-demand routing. It provides a continuous WAN connection. D. DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic.
Identify the command to display the status of the Frame Relay virtual circuit? A.) Router# show frame-relay virtual-circuit B.) Router(config)# show frame-relay pvc C.) Router# show frame-relay pvc D.) Router# show virtual
When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share
The two sublayers of the IEEE Data Link Layer are which of the following? A.) Link and Logical Control B.) Data Link and LLC C.) Logical Link Control and Media Access Control D.) Data Link and MAC
If bandwidth will increase what will happen?
MIDI and MPEG are examples of what layer of the OSI seven layer model? A.) Session B.) Network C.) Datalink D.) Transport E.) Application F.) Presentation
Which show underrate serial 1 status statement indicates that the shutdown command was issued on that interface? A. Serial 1 is up line protocol is up B. Serial 1 is up line protocol is down C. Serial 1 is down line protocol is down D. Serial 1 is administratively down the line protocol is down
What is difference between switch & hub?