Answer / guest

Answer: B

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

2 Answers  

---

What is a network subnet?

0 Answers  

---

. Which command sequence will allow only traffic from network 185.64.0.0 to enter interface s0? A. access-list 25 permit 185.64.0.0 255.255.0.0 int s0 ; ip access-list 25 out B. access-list 25 permit 185.64.0.0 255.255.0.0 int s0 ; ip access-group 25 out C. access-list 25 permit 185.64.0.0 0.0.255.255 int s0 ; ip access-list 25 in D. access-list 25 permit 185.64.0.0 0.0.255.255 int s0 ; ip access-group 25 in

1 Answers  

---

What is size of ipv4 mac address?

0 Answers  

---

Identify the switching method that examines the destination MAC address as the frame is being received then begins forwarding the frame prior to receiving the entire frame? A.) Fragment-free B.) Store and Forward C.) Cut-through D.) Fast forward

1 Answers  

---

Differentiate Logical Topology from Physical Topology

0 Answers  

---

Which command specifies a second subinterface on serial interface 0? A. interface s 0.2 point-to-point B. interface 2 s.0 point-to-point C. suberinterface 2.s 0 point-to-point D. interface s 0 sub 2 point-to-point E. interface s 0.1 point-to-point sub 2

2 Answers  

---

What is the default encapsulation and frame type on an Ethernet interface when enabling Novell? A.) SNAP B.) Ethernet_II C.) 802.2 D.) 802.3 E.) SAP F.) Novell-ether

2 Answers  

---

Which OSI layer incorporates the MAC address and the LLC? A.) Data link B.) Network C.) Physcial D.) Transport

1 Answers  

---

Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame

1 Answers  

---

Describe End to End network services: (Choose all that apply) A.) Best Route selection B.) Accomplished Segment by Segment, each segment is autonomous C.) Flow Control & Data Integrity D.) Best efforts packet delivery

1 Answers  

---

the term which used for describe physical alyout of network mine answer-topology

1 Answers  

---