hi im ccna certified im searching 4 job in networking
domain can any guide wats the rite way of job approach ,wat
r the rite sites for searching job im eagerly 4 ur replies
- 1 Answers
- 3806 Views
- I also Faced
- E-Mail Answers
Answer / jitendra
on behalf of fresher it is hard to get job in network filed so you can try with monster or naukri but if have to study ccnp (only read) then read about firewall then it easy to get job
| Is This Answer Correct ? | 4 Yes | 1 No |
Which type of Ethernet framing is used for TCP/IP and DECnet? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP
Explain why is udp lease favored when compared to tcp?
On an ISDN BRI interface, the control channel is the 'D' channel. What is the rate of this channel? A.) 64 Kbps B.) 1.544 Mbps C.) 128 Kbps D.) 2.048 Mbps E.) 16 Kbps
What does the command show access-lists 101 list? A. all defended access lists B. all access lists within the router C. the contents of standard access list 101 D. the contents of defended access list 101
What are the different types of VPN?
Explain the types of communication in ipv6 ?
Which two physical interfaces support PPP? (Choose two) A. Ethernet B. Token Ring C. Synchronous serial D. Asynchronous serial
In stp which protocol is used for detrming root port root bridge ,forwarding port and blocking port
What is bia?
hi friends i am jitendera kumar sinha.i have a question in mind that what is the diffrence between router and l3 switch i serched on google and found that switch L3 is best in lan and router are best in wan and switch are more faster then router.beside that any short of technical diffrence if you body know then plz plz and plz reply. my 2nd question is that why we canot replace router with L3 switches (donot tell that it is costly then router).i want any technical cause. this is 1 am hope in noon when ever i logg again i will find the answer posted by you. thanks onse again plz pzl make reply thanks jitendera kumar sinha jitenerasinha.it@gmail.com
Hi, All I am configuring EIGRP in Packet tracer, after configuring all the things it is not working but in one condition it is working fine if i am putting all my router and network withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but whenever i am puting different network subnets e.g. in one network it is RA(config-if)#=ip address 10.0.0.1, and in fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in third router RC(config-if)#=ip address 11.0.0.2 and in fa 0/0 172.16.1.10 and after configuring all this serial is showing up and protocol showing up but eigrp process not taking place after adding eigrp configuration, i tried with "no auto-summary" command but not working.. Suggest me where i missing something? can mail me at : gtech.innovator@gmail.com
Which command we use for ping in ipv6?
CCNA 
