what is difference between hub and router.....

5 Answers   Thomson,

---

Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0

1 Answers  

---

Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

Which table find best path?

0 Answers  

---

X.25 is characterized by layer 2 identifiers, and what else? A.) Virtual Lan's B.) Session Layer C.) Transport Layer D.) Routing Updates E.) PVC's

1 Answers  

---

Want to be a Cisco certified person through authorized training and certification center ?

0 Answers   Mercury Solutions,

---

Tell us the name of best path in eigrp protocol?

0 Answers  

---

Which command can verify Application Layer connectivity between 2 hosts? A.) ftp B.) snmp C.) telnet D.) ping E.) traceroute

4 Answers   CTS,

---

Which fields of an IP packet provide for fragmentation of datagrams to allow differing MTUs in the internet? A. Identification B. Flags C. Frag Offset D. Type of Service E. Total Length

1 Answers  

---

Which command would show all Ethernet interfaces with IPX configured on them? A.) show interface ipx ethernet B.) show ipx interface C.) show ipx interface ethernet D.) show ipx E.) show version F.) show run

1 Answers  

---

How do you go to privileged mode? How do you switch back to user mode?

0 Answers  

---

Which router command allows you to view the entire contents of all access lists? A. Router# show interface B. Router> show ip interface C. Router# show access-list D. Router> show all access-list

3 Answers   jetking,

---