Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the command to display the IP host table?
A.) show ip hostnames
B.) show ip names
C.) show hosts
D.) show ip hosts
- 1 Answers
- 6366 Views
- I also Faced
- E-Mail Answers
What route entry will be assigned to dead or invalid route in case of RIP?
Of the following switching types, which one has the lowest latency? A.) Cut-through B.) Fragment Free C.) None D.) Store-and-forward
What ISDN protocol specifies concepts, terminology, and services? A.) Q B.) S C.) I D.) E
Identify 2 features of PPP PAP authentication? A.) Username and password is sent in clear text B.) Authentication messages are sent periodically during the connection C.) More secure than CHAP D.) Remote node is control of authentication process
Which element is used to define the rate in bits per second that a Frame Relay switch agrees to transfer data? A. clock rate (CP) B. Committed Information Rate (CIR) C. Local Management Interface (LMI) D. data link connection identifier (DICI) E. Committed Rate Measurement Intercal (CRIMI)
Can you explain encapsulating, carrier and passenger protocol?
What is mtu and what is its size for transmission?
Which OSI layer handles physical address, network topology? A.) Presentation B.) Physical C.) Transport D.) Application E.) Data-Link F.) Network
Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory
How can you measure out exactly 4 litres of water from a tap using a 3 litre and a 5 litre bucket?
What is the different between console port and auxiliary port?
here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.
CCNA 
