Which of the following are characteristics of UDP? A.) UDP is connection oriented. B.) UDP is used with TFTP. C.) UDP is unreliable. D.) UDP is connectionless. E.) UDP is at the transport layer. F.) UDP uses no acknowledgements.

2 Answers  

---

What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot

1 Answers  

---

What is the command for change serial cost?

0 Answers  

---

Explain how many types of ends in wan?

0 Answers  

---

What is passive topology in ccna?

0 Answers  

---

IGRP supports a feature that allows traffic to be distributed among up to 6 (4 default) paths to provide greater overall throughput and reliability. What is this called? A. unequal-cost load balancing B. equal-cost load balancing C. proportionate load balancing D. low cost load balancing

1 Answers  

---

How many ways to access router?

0 Answers  

---

Identify the purpose of ARP? A.) Avoiding routing loops B.) Determining a workstation's IP address C.) Sending a directed broadcast D.) Determining a workstation's MAC address

3 Answers  

---

which algorithm as defined by the transform set is used for providing data confidentiality when connected to tyre?

0 Answers  

---

What is formula of hold down time of eigrp protocol?

0 Answers  

---

Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch

3 Answers  

---

hi shain/sudeep and rest of all plz answer these question for help some one as soon as possible what is stub area what is transit area let there are three area in ospf a0 a2 and a3 if a2 and a3 is coneted through each other will they comnicate

3 Answers  

---