Which can be logged by IPX extended access lists? A.) source address B.) protocol C.) source socket D.) access list number E.) destination socket F.) destination address

1 Answers  

---

Which service takes information from multiple sources and allocates bandwidth on a single media? A. Time-division Multiplexing (TDM) B. Signaling System 7 (SS7) C. X.25 D. Frame relay

1 Answers  

---

How do you depict an IP address?

0 Answers  

---

Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet

2 Answers  

---

What is VLSM? how to Calculate VLSM? where it is use and why?

13 Answers  

---

Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport

1 Answers  

---

Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0

1 Answers  

---

Explain the terms unicast, multicast, broadcast and multicast.

0 Answers  

---

Which two statements accurately define IP addressing rules? (Choose two) A. IP multicast addresses start with 240 B. A host Carbon of all 1 a indicates a network broadcast C. The value of zero (0) in the host Carbon means all hosts on the network D. IP addresses are four octets long and contain a network Carbon and a host Carbon

2 Answers  

---

When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?

2 Answers  

---

What does the trace response !H mean? * A: Network unreachable * B: Not forwarded due to ACL restriction * C: Protocol unreachable * D: Port could not be reached

2 Answers  

---

Given the following output, how can we close Telnet session 2? (Choose two) CCNA2620#show sessions Conn Host Address Idle Conn Name 1 131.108.100.152 131.108.100.152 0 131.108.100.152 *2 126.102.57.63 126.102.57.63 0 126.102.57.63 ❍ A. Press the Enter key and enter exit. ❍ B. Enter disconnect 2. ❍ C. Press the Enter key and enter disconnect 2. ❍ D. Enter close 2.

1 Answers  

---