What is the minimum and maximum request timer?

0 Answers  

---

What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route

1 Answers  

---

Which statement is true regarding full duplex? A.) Allows for transmission and receiving of data simultaneously B.) Only works in a multipoint configuration C.) Does not affect the bandwidth D.) Allows for transmission and receiving of data but not at the same time

2 Answers  

---

Using the TCP/IP protocol suite, a message is sent from host A to a destination IP address on the same LAN. How does host A determine the destination of a MAC address? A. It uses a proxy APP B. It uses APP requests C. It uses PARP requests D. It uses a router lookup table

1 Answers  

---

In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physcial interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay

2 Answers  

---

Switching methods include cut-through, store and forward, and a modified version of the first two methods. Which statement about switching methods is true? A. The store and forward method has low latency B. The cut through method of switching has high latency C. The modified version holds the packet in memory until 50 percent of the packet reaches the switch D. The modified version holds the packet in memory until the data spoon of the packet reaches the switch

3 Answers  

---

Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX

3 Answers  

---

My question is how windows pc will act as a router? Jitendra understand this question? I again want to ask you is it possibele for windows pc to act like a router

2 Answers  

---

In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay

1 Answers  

---

Does a bridge divide a network into smaller sections?

0 Answers  

---

Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) Ping D.) Console E.) Trace

2 Answers  

---

What is the protocol and what is the purpose of the following address? 238 255 255 255 A. IPX a SAP broadcast B. IP a multicast group C. IP a reserved address D. IP a directed broadcast E. IPX a flooded broadcast

3 Answers  

---