How many networks route update does a router recieves in RIP at once ?

3 Answers   ComNet,

---

friends i have 3ree prob which is asked in ibm india in technical round 1 what is ftp(this was easy i had answered) 2 why we use ftp(i think it is a tough one) 3 how can we enable ftp in the widows xp. friend i need these question answer as soon as possible if it is possible to reply within the eveing then i always obeyliged to you i am espacily looking towards the jitendera sinha who make most of the valuable answer loking toward you nidhi mall

3 Answers   IBM,

---

What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP

2 Answers  

---

Identify 3 characteristics regarding IP access-lists? A.) Can be configured as a standard access-list B.) Can be run from another router running IP C.) Can be configured as a named access-list D.) Are the same as IPX access-lists E.) Can be configured as an extended access-list

1 Answers  

---

When ospf protocol advertise its routing table?

0 Answers  

---

Why mac address called physical address?

0 Answers  

---

Which of the following describe SMTP? A.) Used for downloading files to the router. B.) Used for sending e-mail. C.) Uses TCP. D.) Uses UDP. E.) Uses port 25. F.) Used for managing IP devices.

1 Answers  

---

What are the steps of conversion for data encapsulation?

0 Answers  

---

in router we use config# ip host router2 ipaddress we use it for ping the neighbor router using name provided by us ..........instead of ip address in this max how many ip address can be assigned thanks

1 Answers  

---

What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers  

---

what is eigrp and what is the benfit of eigrp over igrp what is route summryization if one the router route is not showing the what should be problem how to resolve these problem what is fessible suceer. is the load balncing is one of the property of eigrp what is the metihod of authantication what is the diffrnec betwee pap and chap what is stp command for enabling stp and rstp why switching loop occur what is the main factor of ocuring switch loop what is the mechnaism for stoping the roting loop what is best diffrence betwwen ospf v1 nad ospf v2 what is vtp what is the diffrence between vtp version 1 and veron 2 what is the ip address what is the diffrence betwwen ip address mac address what is dhcp and how it work what is 3 way hand shake what is the difrence betwwen network id and brodcast id what is the network id for 111.111.111.10/29 what is the command for enabling vlan on 3650 csco switch

1 Answers   HCL, Microland,

---

Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network

1 Answers  

---