Where are the successive approximation type adc’s used?
No Answer is Posted For this Question
Be the First to Post Answer
What frequency bands are used in satellite communication?
WHAT IS THE ELLIGIBILITY FOR ADMISSIONS IN NITS
what is the difference between pre-emphasis and modulation?
Which questions ask for ccna certified candidates
In 8086 why even address location takes two bus cycles whereas odd address location takes only one bus cycle??
Explain what is an excitation table?
what is the use of rms value ,crest factor , Q- factor,form factor
There are 4 segment registers in 8086 microprocessor.Each of the segment register is of 64kb.Then (4*64)=256kb.The total memory in 8086 is 1mb.What about the rest of the memory space?
Each Electronics Exchange operates on -48 volt. What is the reason that exchange operates only -48 volt DC?
what do you understand by microwaves? why these are called micro
Which of the transistor currents is always the largest? Which is always the smallest? Which two currents are relatively close in magnitude?
what were the challenges you faced during the project technically and how did you cope up with that?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)