Explain the terms real power, apparent power and reactive power for ac circuits and also the units used.
- 0 Answers
- 632 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
where can i get the previous years question papers for APGENCO exam.
Why is shaft current insulation required on large motors & when should it be checked i.e. before or after assembly?
Why we use mho Relay in long transmission line?
what is the current density of copper & alluminium.
Why is better to have a minimum ceiling voltage of 250% than 160%?
Why r u using pf panel. what the uses
why wave traps are placed only at y and r phase?
what is the difference between HV and LV Breakers?
4 Answers GM General Motors, OEG,
What is the range of the stator resistance of 3 phase induction motor?
why Square root 3 used for three phase?
when meggering a 3ph,480v oil reservoir heater on a regen gas compressor, why do I get a reading to ground when meggering phase to ground? shouldn't it read opened or is there something that makes it read closed? on the same heater, when ohming, it reads open. thanx
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a campus site?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
