boiler fusible plug melt down, normally melt down due less water or feed pump failure, but is there any possibility of fusible plug melt down due to high temperature in firing zone and at that time water level is perfect at it's level.

1 Answers  

---

What type of pump is main L.O. pump?

1 Answers   RRB,

---

what is milling and types of milling?what is drilling and types of drilling? what is tapering and their types?

0 Answers   IOCL, TVS,

---

What is g.i.?

0 Answers  

---

what will happen when petrol pour into diesel engine?

17 Answers   APGenco, Hero Honda, Lupin,

---

Sir , i am a Mechanical Engg Student. Pls send me the JinDAL STEELS AND POWER LIMT.. RECRUITMENT DOMAIN AND APTITUDE BASED SAMPLE QUESTION Papers.. JINDAL IS MY DREAM JOB..PLEASE HELP ME AND GUIDE ME TO BE SUCCESS,I NEED THE SAMPLE QUESTIONS FOR URGENT. MY ID--sampathsurya@yahoo.com.

0 Answers   Jindal,

---

what's are the Unit's of RPN (Risk Priority Numnber)

2 Answers  

---

Explain what is torque?

0 Answers  

---

What is the difference between alpha iron, delta iron and gamma iron ?

0 Answers  

---

At what principle Air Compressor Works?.. What are the rule governing air compressor operation:

2 Answers   DAE,

---

25 questions in 25 minutes were asked by L&T corein mechanical engg test on 28 nov 2011 are as follows:- L&t mechanical consists of 1> airfuel ratio 2> mollier chart for flow rate 3>homogeneous or hetreogeneous mixture 4>sublimation curve 5>effect on room temperature when fridge is opened 6>cop of refrigerator 7> punching and piercing uses shear or not 8>method not used for tapering 9>forming method not used for productn 10>numerical regardng no.of cuts 11>flow of chip is controlled by which parameters 12> property important for impact loading 13>stifness of spring when it is cut into 2 pieces 14> device reqd for energy fluctuation 15> property on which rivet is selected 16>crowning to prevent flat belt pulley errors like undercut 17>cavitation occurs at which stage 18>qstn regardng inventory control 19>for ship vessel industry what sort of plantlayout reqd 20>value engg definition 21> qstn on how the extnsn occurs for uniform loading 22> qstn regardng stress actng on the shaft23>maximum value of mohr's circle diameter 24>qstn regardng meshing of teeth 25>qstn on helical gear reqrd better read G.K.PUBLISHERS GATE PAPERS ESPECIALLY FROM 1993 to 2003 ESPECIALLY THEORY QUESTIONS RATHER THAN NUMERICAL QUESTIONS

0 Answers   L&T,

---

what is the difference between a distillation column and tower

2 Answers  

---