Identify 3 features of IGRP?
A.) Composite metric
B.) New horizon
C.) Flash updates
D.) 60 periodic updates
E.) Poison reverse
Answer / guest
Answer: A C E
IGRP uses a composite metric made up of bandwidth and delay
by default,
it updates every 60 seconds and will trigger an update if
the topology
changes.
Is This Answer Correct ? | 2 Yes | 1 No |
What is the key advantage of using a switches?
Which three are typical operational phases in a basic connection oriented neloyord service? (Choose three) A. call setup B. data transfer C. load balancing D. call termination E. call priortization F. data segmentation G. data link identification
How does OSPF calculate its Metric
Tell me how much internal and external ad of eigrp protocol?
In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to NVRAM before becoming enabled
srry for inconvnce ..here is complete qs...ignore the previous 1 3 router configured with RIP & Ripv2 rotuer 1- connected with router 2 having sr ip 10.0.1.2 routing : ripv2 E0:192.168.1.10 router 2: connected with router 1 and router 3 having sr 0 ip 10.0.1.3 & sr 1 ip 11.0.1.2 routing :rip & ripv2 E0=192.168.10.2 router 3: connected with router 2 having sr ip 11.0.1.3 routing: rip E0=172.16.10.2 is there communication possible?
Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department
What is the default switching method for the Cisco 5000 series? A.) Cut-through B.) Store-and-splice C.) Latency D.) Store-and-forward
What does a metric of 16 hops represent when using RIP? A.) Number of hops to the destination B.) Destination unreachable C.) Number of routers D.) Bandwidth
What does the ping response & mean? * A: unreachable * B: congestion * C: user interrupt * D: unknown packet type * E: lifetime exceeded
hello i am new to this, i need to know how will i complete a basic scenario that ask the required number of networks that is 80 and the minimum number of host that is 3000 and the network address is 10.0.0.0 and i need to need how to compute to get the answer on what is the subnet mask.
What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC