The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP

1 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make fowarding decision using MAC address E.) Create collision domains

1 Answers  

---

Identify 2 transport layer protocols? A.) IP B.) TCP C.) CDP D.) ARP E.) UDP

2 Answers  

---

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

1 Answers  

---

What is the protocol number for TCP? A.) 80 B.) 21 C.) 11 D.) 6

1 Answers  

---

---

Which of the following provide connection-oriented transport to upper layer protocols? A.) SPX B.) RIP C.) NLSP D.) NCP

1 Answers  

---

Which layer is responsible for routing through an internetwork? A.) Physical B.) Session C.) Network D.) Transport E.) Application F.) Data Link

4 Answers  

---

Which protocols are link states?

0 Answers  

---

What are the advantages of a layered model in the networking industry?

0 Answers  

---

hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

---

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

2 Answers  

---

Hi, I cannot download anything on my office pc. only because of that i want online practice sites. anyway thanks for providing me website

0 Answers  

---