Answer / vamsi

I am vamsi , a mechanical graduate, 2006 fresher. I have attended 'Robert
Bosch' written test on 14 th November.

Robert Bosch Placement Papers | Robert Bosch Interview Procedure |
Robert Bosch Aptitude Questions | Robert Bosch Technical Questions |
Robert Bosch Interview Questions


Only 60 to 70 people (Mechanical) were allowed to write the test who came
with call letters.


TOTAL DURATION OF TEST IS 90 min & "NEGETIVE MARKING IS THERE".

SECTION 1

Total 50 questions correct Answer +2 marks , wrong answer -1 mark.
Out of 50 ques....40 from engineering and 10 from aptitude.

SECTION 2
Total 25 questions on English.

Paper is as follows...

SECTION 1:

1. Two forces acting along the same line but in opposite directions. they
are called (c)
a) Concurrent b) coplanar c) collinear d) non concurrent

2. Two basic systems of forces (c)
a) Coplanar, concurrent b)non concurrent, concurrent
c) Coplanar, non coplanar d)concurrent, non coplanar

3. Formula for power in HP

4. Forces lying in the same plane but never met (b)
a) concurrent b)parallel c) d)

5. Ger ratio for helical gears one of 30 tooth and the other 60 tooth
a)800:1 b)2:1

6. Four rectangle strips of size 10 X 1 inch r placed on a table as shown
in the figure. what is the area covered on the table. (a)
a)36 b)40 c)1600 d)80

7. If you traveled 45 min at 4 miles per hr and 30 min at 3 miles per hr.
what is the distance covered by you in 1 hr and 15 min.
(b)
a) 8 miles b)6 miles c)7miles d)10

8. A ball of weight 10N is dropped freely from rest at a height of 4 mts.
what is its total mechanical energy after it has travelled 1 meter.

Robert Bosch Placement Papers | Robert Bosch Interview Procedure |
Robert Bosch Aptitude Questions | Robert Bosch Technical Questions |
Robert Bosch Interview Questions



9. Two bodies of same mass r traveling at a velocity of 2 m/sec in
opposite direction. After collision one travelled with 1.8 m/sec what
about the other..

a) equal to 1.8 m/sec b)more than 1.8
c) Less then 1.8 d) can not say

10. If X-component of a force is -Ve and Y-component is +Ve, in which
plane the Resultant would be (a)

a) First quadrant b) second c) third d) fourth

11. A body is said 2 b in equilibrium (c)

a) if it is in rest b)if it is I uniform velocity
c) if the sum of the forces acting on it is zero d)none

12. X15-X13+ X11-X9+X7-X5+X3-X=7 than value of X16 ?

13. A chain of length 1 mt and mass 1 kg is placed on a table.What length
of the chain must be hanged freely from the table so that is will drag the
remaining chain freely (d)

a).55 b).66 c) 0.5 d).75

14. Main purpose of governer (d)

a) to live happy life b) to increase engine speed
c) to decrease engine speed d)to run engine smoothly

15. A steel beam of mass m and length l is placed on a surface.a couple u
is applied at the ends to rotate the beam at 90 0 . what is the work done?

16.A & B r two weight lifters. A can lift 100 pounds 10 times a minute,
where as b lifts 100 pounds 10 times a sec.who is doing more power and
work. (c)

a)A&B b)A omly c) B only d) none.

17. A ship is 77 Km away from the shore.It had a leak due to ehich water
is flowing into the ship @ 1 ton /min .A pump is used to pump the water
out of the ship @ 30 ton/ hr The ship sinks if the water Qty reaches 210
ton.what should b the speed of the ship to reach the shore before it
sinks. (b)

a)7 mph b)11mph c)15 d)20

18. Very simple ..que..find the hypotenuse ..

1) Sides 8, 11, find hyp 2) a similar one..to find side..

19. Which is the largest side in a right angled triangle

a) hypotenuse b)edgescent side c)opposite side

20. The angle of depression from the top a building to another building
is 120. the distance b/n the two is 50 mts. What is the difference in
the height of buildings. (a)

a) 10.6 b)20.3 c)10.4 d)48.9

Robert Bosch Placement Papers | Robert Bosch Interview Procedure |
Robert Bosch Aptitude Questions | Robert Bosch Technical Questions |
Robert Bosch Interview Questions


21. Simplyfy [ 3v--- 27 - v-(27/4)]2

22. Belt drives are mainly used for (d)

a)to reverse the direction of power in belts. b)to transmit it power. c)
to ....d) all

23. BS thread profile has

a)141/2 0 b)450 c)250 d) 90 0

24. The main purpose of bearings (b)

a)to reduse noise. b)to reduce friction c) d)

25. When compared to spur gears bevel gears are more .. (a)

a) noisy b)smooth

26. The angle b/n bore axis of gear and the tangent to the teeth profile
is called (b)

a)P.A b) helix c)

27. The circle touching the outer edge of the teeth is called (c)

a) Base circle..b) pitch crcl c) addendum crcl d)...

28. The area of the piston A is 10 cm2 and that of B is 4 cm 2. If 10n
load is applied on the piston A what is the force on the piston
B. (c)

a)100N b)40N c)10N d)none

29. The force exerted by a spring depends on (d)

a)Material of the spring b)Design of the spring c)Length of the spring
d)all

30. If a body is isolate from it's mating parts and all forces acting on
it r shown then it is called. (c)

a)BM diagram b) SF diagram c)free body diagram d)none

31. A coin and a ring of same mass and diameter r allowed to roll smoothly
from the top of a inclined plane. which one reaches the bottom first.

a)coin b) ring c)both reaches same time d) none

32. A ball is thrown horizontally .After hitting the ground it again
raises with some velocity. this is bcoz.. (b)

a) ball is stil having velocity b) it gains momentum from the ground.
c) d)

33. a problem on balancing masses..

34. a mass is rotating..with rad /sec..simple problem ..on basics..

35 given 0<a<b<c<d then which of the following is least value. (c)

a)c+d/ a+b b)c+a/b+d c)a+b/ c+d d)...

Remaining questions i did not remember .

SECTION 2:

51 to 55 } Passage with blanks..

56 to 60 } antother passage with blanks..

61 to 65 proverbs..

1. don't look a gifted horse..

a)at b)in life... c) in dreams d)

2. more hands.......

a) make more work easy b)more light work c) d)

3. people living in glass houses....

a)may not throw stones b)didn't throw stones c) cannot throw stones d)
should not throw stones


4 and 5 like this only.


65 to 75 appropriate meaning

1. Go for ......... (a)

a) try b)get it c)quit d)

2. Go overboard.... (a)
a)exaggerated b)exagerate c) exagratred d) none.

3. Go bad ........
a).... b)bad c)not good d) none

4. go wrong ........ (b)
a)fail b) mistake c) d)

5. meaning of batten .... (a)
a) noun :a long wood of metal strip b)....... c)..... .d).....

Thats all guys waiting for results.

Robert Bosch Placement Papers | Robert Bosch Interview Procedure |
Robert Bosch Aptitude Questions | Robert Bosch Technical Questions |
Robert Bosch Interview Questions

Trylogic Interview Paper

1 Answers   Trylogic,

---

Geometrics placement papers -------- placement paper 2

1 Answers   Geometric Software,

---

Placement Paper of Valuelabs On Aug 2006

2 Answers   Value Labs,

---

MOTOROLA PLACEMENT PAPERS ---- Placement Paper 1

1 Answers   Motorola,

---

placement papers

1 Answers  

---

---

HP Experienced Paper --- 2007

2 Answers   HP, TCS,

---

Hi there, few days back i had an interview with OPI Global(Outsource Partner International). The first round was suppose to be written Test. I wasnt sure about what kind of questions will be asked, so i just googled for the same but did not find any appropriate results or may be i was not able to find it. So basically I am gonna write about the questions and their level of difficulties with a few sample questions. basically there are 5 sections and total 40 Questions: 1. General English 2. Computer Skills (Mostly Excel) 3. Analytical 4. Aptitude 5. Finance & Accounts Sample Question Section 1 Ques - I stay ___ the city center Option - a. by b. near c. nearby d. Ques - I ___ television this evening Option - a. saw b. view c. watched Section 3 The question was too long so i just cant write here but can tell you the level of difficulty. It was pretty simple but you just need to read it care fully and you would be able to solve it easily. Section 4 I am not very good at aptitude so found this section little tough for me. Question - If 10 ppl can finish a work in 10 days then how long 8 ppl will take to finish the 3/4 of that work Option - I dont remember. Question - Car A runs at a speed of 40 miles and leaves the city at 3.20 PM, Car B runs at a speed of 50 miles and leaves the city at 4.40 PM. At what time Car B will catch Car A? Option - I dont remember the options Section 5 I just cant remember the questions but would suggest you to read abt personal, real and nominal accounts. Read little bit abt depreciation and basic stuffs.

0 Answers   OPI Global, Outsource Partners International,

---

Aricent Paper & Interview : : 06 Mar 2007 : : Patiala

21 Answers   Aricent, iNautix, TCS,

---

BHEL Mechanical Engineering Paper - 11 Feb 2007 - Trichy

8 Answers   Bhel,

---

My interview Placement paper with Dell ---- 2006 10 July

5 Answers   247Customer, DELL, HCL,

---

Want BEL Placement papers

2 Answers   BEL,

---

College Of Applied Science

3 Answers   Wipro,

---