Can Anybody tell me if I wanna block all MP3,video sites from cisco 2600 router,how shall i proceed with ACL's?? Please post the steps for the following alonge with detail. Thanks to you all ..appriciated

5 Answers   Cisco,

---

Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) Ping D.) Console E.) Trace

2 Answers  

---

Which statement about the flow control function of TCP is true? A. TCP makes no snarl to check for lost or duplicate data packets B. The application layer must sequence data packets when using TCP C. TCP controls the flow of UDP data through negative acknowledgements (NAK) D. TCP is a connection-oriented protocol that acknowledges receipt of data packets and is considered reliable

1 Answers  

---

Can you explain static and dynamic tunnels?

0 Answers   CCIE,

---

Which command can verify Application Layer connectivity between 2 hosts? A.) ftp B.) snmp C.) telnet D.) ping E.) traceroute

4 Answers   CTS,

---

What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

mention the funtions about connection oriented and connectionless protocol and how it works ?

7 Answers  

---

What are the three phases of PPP session establishment? A. Link establishment phase B. Authentication phase C. Network layer protocol phase D. Handshake phase E. Dial-in phase

2 Answers  

---

Wnat do you know about zenpeck

2 Answers  

---

Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  

---

what is route aggregation

2 Answers  

---

A router on one side of a PPP link uses the resonance RTR1 and the password COPP1-PWD. Which configuration line on RTR1 enables a connection between RTR1 and another router named RTR2? A. username, RTR2 password COPR1-PWD, B. username, RTR1 password COPR1-PWD, C. username, RTR2 password COPR2-PWD, D. username, RTR1 password COPR2-PWD,

1 Answers  

---