Answer / ch.koteswara rao

Axial play is the clearance is allowed in axial direction (longitudinal direction) of a shaft adjusted by check nut mechanism to arrest the movement when rotating within the set clearance
Radial play is the play in the radial direction while rotating
not allow beyond that value to control run-out of a shaft to impart required/desired accurate rotation for allowable/designed rotation.Its depends on selection and type of bearing or clearance allowed in friction type of bearing

IN 6" PIPE IF FEED WATER FLOW IS ABOUT 130 T/H SO SAME DIAMETER OF PIPE HOW MUCH STEAM FLOW SHOUD BE?

0 Answers  

---

why the backwheel of tractor is bigger than frontwheel?

12 Answers   HAL, HMT, MAHINDRA,

---

what is machin

4 Answers   Jindal,

---

We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?

0 Answers   PetroVietnam,

---

Which bearings are used in the reciprocating compressor?

2 Answers   Manali Petrochemicals,

---

what is different between mechanical seal and oil seal

1 Answers   CMS, Essar,

---

Which mechanism is used to hold the gear ?

3 Answers  

---

Explain how does hydraulics work?

0 Answers  

---

send interview questins about pro_e to me mohanrvs_1984@yahoo.co.in

0 Answers   Bhel, Wipro,

---

what is the three phase induction motor? what is difference between motor used in household instruments and induction motor?

0 Answers   Essel,

---

What is the effect or reheater in the gas turbine?

4 Answers   Bhel,

---

what is difference between 1ton to 1HP

2 Answers  

---