If you have configured IPX on a Serial interface, which
command would
display the IPX network and node address on the Serial 1
interface?
A.) show interface
B.) show ipx s1
C.) show interface s1
D.) show ipx int serial 1
E.) show ipx int brief
- 1 Answers
- 3639 Views
- I also Faced
- E-Mail Answers
what are the port numbers for DNS,FTP,TELNET,SMTP,NNTP
5 Answers Airtel, Walton Group,
Novell NetWare has an Ethernet frame type called Ethernet_802.2. What is the matching Cisco command line keyword for this encapsulation method? A.) gns B.) arpa C.) snap D.) sap E.) novell-ether F.) dix
Which ISDN specification series deals with Concepts and Terminology? A.) C- Series B.) I- Series C.) Q-Series D.) 911-Series E.) J-Series F.) F-Series
Identify the true statements about the following access list: Access-list 101 deny tcp 192.10.172.0 0.0.0.255 any eq 23 Access-list 101 permit ip any any A.) This access list prevents the host 192.10.172.0 from telneting B.) This access list prevents any telnet traffic from subnet 192.10.172.0/24 C.) This access list filters some telnet access D.) This access list denies any telnet traffic to subnet 192.10.172.0/24 E.) This access list is invalid F.) The netmask on the this access list is reversed
How many Frame-relay encapsulation types are available with Cisco routers? A.) Four B.) Two C.) Five D.) Three
What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message
Which two commands allow you to verify address configuration in your unternetword? (Choose two) A. ping B. trace C. verify D. test ip E. Echo ip F. config ip
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active
which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..
Which command displays the intenances using a given access list? A. show filters B. show ip interface C. show active lists D. show interface paramaters E. configure ip access lists F. show access-list interfaces
What is link aggregration?? How many types of protocol are used on that???
CCNA 
