Answer / guddu singh

Their are not
necessary the size.
About aggregate we
always calculate it's
grading. Well
graded aggregate
always used for a
concrete mix design.
According to IS ph
value of water always
must between 6-8.

Answer / sjtbehera

It is bewteen 6mm to 40mm, depending upon rcc.

Answer / pravesh jha

ph value of water should be more than 7 because if the ph value of water will be below 7 than it will be acidic and it cause corrosion in reinforcement...so for corrosion resistance the ph value is taken more than 7

Answer / vki

1 20 mm
2 note less than 5

Answer / guest

20mm 7

what is a moment connection and shear connection ? where it provided ? why it provided ?

1 Answers  

Bearing capacity of soil determined as per ASTM is to design the foundation size.what is the importance of EV1/EV2 value as per DIN .My consultant ask me to test the the soil as per din to find out this ratio to assess the compacted strength of soil ,,?? is it meaning full ??

0 Answers  

what would be compressive strength of cube for 7 days if design mix of M15

1 Answers  

How much cum. Brick work can do by 1 madon

0 Answers   DLF,

What is the cost difference between site mix and ready mix concrete per cubic meter

0 Answers   L&T,

10x10 slab design

1 Answers  

At one time what is the height of Lift for concreting for Bridge Piers Class B Loading and refer the code.

0 Answers   Kirloskar,

if 6.0M x3.0M Boat floating on water One person Sit on Boat Then the boat Sink about 15cm .Then what is the wt of person.

3 Answers  

what radial pressure, the NP2 class rcc pipe can sustain?

0 Answers   DVC,

Why nautical mile is different from statute mile?

0 Answers  

what is the density of fine sand grade-2

3 Answers  

How we calculate the service time of buildings

0 Answers   SPML,