Answer / raja

Assume we give square wave of 50 hz supply to txmr .
from 0 to postive maximum and then it will remain in maximum
value and same for negative axis also . since the rate of
rise from 0 to max + value / _value occurs at one instant of
time and not gradual . there will be no emf at secondary
terminals .

E = 4.44f*flux*turns*sinwt ( w =2pi* freq)- instantaneous
value of secondary emf .

Answer / pritish

it produces only impulse wave not triangular wave

Answer / khgyfkt

you will be getting a triangular wave output..

why star point of motor shall not be grounded?

8 Answers  

---

In n high voltage 11kv system What happened if 1 of CT cable (IDMT) loose.Will e/f or o/c trip.please explain detail

1 Answers  

---

Pls explain about vfd control?Where it is used, Give some example?

3 Answers   Siemens,

---

Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA

0 Answers  

---

Is there is any difference between AC and DC Cables

1 Answers  

---

In a transformer ,when voltage decreases current increases. but this is a violation of oms law.why?

15 Answers  

---

defination of reactor

3 Answers  

---

what is the fullform of mccb

10 Answers   Thermax,

---

Why have the transformer one earthing to their neutral? Why have the transformer many earthing to their body?

1 Answers  

---

what are eddy currents

2 Answers  

---

1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?

0 Answers  

---

How to calculate the electrical load for a standard telecom BTS shelter and capacity of DG set required to cater to this load?

3 Answers   Bhel, INDUS, Indus Towers,

---