how to store the thunder power?
Answer / s.sheik hussain
thunder is a bulk amount of load,it's infinity of load depends nature,may storage device blast ,it cant be design any storage device for actual capacity of thunder.
Thunder can be heard from a maximum distance of about 10 miles (16 km) under good atmospheric conditions.different times from the sound produced along its length. People have experienced injury and property damage from the sound of thunder at close range.
Is This Answer Correct ? | 9 Yes | 2 No |
I have calculated load for an office building which is 1200 KW as all the load is single phase therefore its 1200 kw single phase. Now i have to design Transformer and Generator for this load Please kindly give me exact answer that how much capacity of Three Phase Transformer and Three Phase Generator is required for this load.
If the load is 10Kw and power factor has to improve from 0.5 to 0.8,how can we select the capacitor rating accordingly.Illustrate by showing formula?
What is Isolation Transformer???
what happen if transformer neutral not earth
what is differance between kvarh $ kvah
How damper winding in synchronous motor suppress Hunting?
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
in a distribution board,if we have a load and we have selected a cable after making all calcs (Deratings and V.D , ect...) the cable we have selected was 10mm.sq. now, shall the internal cable inside the switchboard should be 10 mm.sq Like the external or it can be Less???? if somebody have an specs or information he can help D:
if a train is running on a speed of 40 K MPH and crosses a individual passing by him in 48 secs who is riding a horse with a speed of 25 K MPH. what is the length of the train?
why there is a fault occurs, if a phase wire touches ground.. and the fault not occurs when we connect a bulb between phase and ground..??
Electrical breakdown strength of an insulating material depends on............?why because?
I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.