difference between altenator and dyanmo?

Question Posted / manish.tyagi51

3 Answers
5733 Views
Bhel, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

difference between altenator and dyanmo?..

Answer / rajen thakkar

The Basic different is that The equipment which generates
AC supply is called alternator. and which is generates DC
is called dynemo.

Is This Answer Correct ?

20 Yes

1 No

difference between altenator and dyanmo?..

Answer / shivanand kalabeelagi

in alternator field is rotating and rotoar is stationary but in
dyanamo opposite of alternator.
dynamo produce DC current where alternator produce AC
current.
alernator produce same current even at low speed but in
dynamo current is directy propotional to speed.

Is This Answer Correct ?

12 Yes

0 No

difference between altenator and dyanmo?..

Answer / vijay kumar

1.dynamo is nothing but an d.c.generator in which armature
rotates and field is stationary,armature produces
alternating supply which is further converted to
unidirectional supply by means of commutator(ac to dc).
2.alternator(a.c.generator)in which armature is stationary
but field is rotating due to some advantages in which ac
supply is generated is directly taken to the load without
using commutator(also called as commutator less generator).

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

how to calculate bearing number?

4 Answers NRB Bearings, NTN, SKF,

Horse power of i.c. Engines can be expressed as rac rating, sae rating, or din rating. To which countries these standards belong ?

0 Answers

The 4/5th part of volume of a piece of wood is swiming as well as sunk in a fluid. if the relative dencity of wood is 0.8 then what will be the dencity of fluid in KG/M3. PLEASE ANSWER WITH SOLUTION.

2 Answers Essar,

what is the length of a cigratte?

4 Answers Marlboro,

Why stop ratio valve is necessary before gas control valve in GE gas turbines.

1 Answers GE,

How to increase the humidity content in an air?

4 Answers

what is punching force required for embossing of depth 3.5mm and diameter 58mm

0 Answers Omkar Solar System,

What is base design drawings?

0 Answers JMC,

mahindra & mahindra's technical & aptitude questions