Interested to Buy Any Domain ? << Click Here >> for more details...
Choose the following that are benefits to segmenting with
router:
A.) Flow Control
B.) Manageability
C.) Multiple Active Paths
D.) Explicit packet lifetime control
- 1 Answers
- 5915 Views
- I also Faced
- E-Mail Answers
i have donE B.E. IN COMPUTER SCIENCE AND THEN CCNA CERTIFICATOIN PLEASW LET ME KNOW IF ANY COMPANIES R HIRING FRESHERS PLEASE REPLY ON MY EMAIL ID karnailthakur@gmail.com
What route entry will be assigned to dead or invalid route in case of RIP?
What does the IPX maximum path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)
What is the utility of ping?
Identify the correct IGRP configuration? A.) Router# router igrp 100 Router# network 10.0.0.0 B.) Router(config)#router igrp 100 Router(config-router)#network 10.0.0.0 C.) Router(config)# router igrp Router(config-router)# network 10.0.0.0
Explain on which interface we always apply access-list?
Identify the components in the following command 'interface serial0/1/1' A.) Serial interface, port number 0, slot 1, port adapter 1 B.) Serial interface, slot 1, port number 1, port adapter 0 C.) Serial interface, slot 0, port adapter 1, port number 1
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share
The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full
Explain the difference between baseband and broadband transmission in ccna?
Explain the difference between named and extended acl?
Identify the command to view the configuration-register value? A.) show register B.) display config-register C.) show config D.) show version
CCNA 
