HI friends.
i need a suggestion and looking towards you foryours
valuable suggestion
friends i have completed ccna now i want to done red het
linux system admnistration and networking i am liitle bit
confuse betwwen them which one is better for me for job
point of view
reply soon
waiting for your reply
- 1 Answers
- 3321 Views
- I also Faced
- E-Mail Answers
Answer / jitendera sinha
friends i am little bit confude between ccnp and red hat
Linux system admin and networking.
what i have to do
plz tell
looking towards you
jitendera sinha
| Is This Answer Correct ? | 2 Yes | 0 No |
Which two statements about integrated services digital network (ISDN) are true? A. ISDN provides data only capability B. ISDN provides an integrated voice/data capability C. The ISDN standards define the hardware and call setup schemes for end the end digital connectivity D. Users receive more bandwidth on WANS with a leased lin of 56 Cops than with multiple B channels
Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route
Repeaters work at which layer of the OSI model? A.) Network B.) Session C.) Transport D.) Physical
Explain the terms unicast, multicast, broadcast and multicast.
Explain what are the ranges of private ips?
Identify the type of routing protocol that exchanges entire routing tables at regular intervals? A.) Link state B.) Interior gateway protocols C.) Appletalk routing D.) Distance vector
What is the default size of a standard ping on a Cisco router? * A: 100 bytes * B: 32 bytes * C: 10 bytes * D: 16 bytes
Which element is used to define the rate in bits per second that a Frame Relay switch agrees to transfer data? A. clock rate (CP) B. Committed Information Rate (CIR) C. Local Management Interface (LMI) D. data link connection identifier (DICI) E. Committed Rate Measurement Intercal (CRIMI)
Identify the X.25 addressing standard? A.) X.121 B.) X.25a C.) ITU-1 D.) Q933a
Identify the hardware component used to store buffers, tables, running-configuration etc? A.) NVRAM B.) ROM C.) RAM D.) Flash
Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface
What is the routing algorithm used by RIP and IGRP? A.) OSPF B.) Link-state C.) Dynamic D.) Distance Vector
CCNA 
