Is there a lower limit to the gland surface finish for
static O-rings, gaseous system?
surface finish table lists 0.41-0.81 micro-meters for static
gaseous systems. What is the drawback of using a smoother
surface finish lower than 0.41?
No Answer is Posted For this Question
Be the First to Post Answer
what is the main purpose of deaerator in thermal power plants?
what s available NPSH and required NPSH? which is given by manufacturer and which is not? what is the role of customer in choosing NPSH?
How to make a vacuum
please send the last 5 years {{{JUNIOR ENGINEER GRADE II - MECHANICAL RRB CHENNAI}}} TECHNICAL question papers
Explain how are the pneumatic system and the hydraulic system similar?
Where do railway steam engines carry there water?
What is wrap-around?
what is difference between (pressure and stress), (sencitivity and efficiency) .
How the speedo meter ratio was decided for vehicle?
What is cavitations?How it is generated?
Explain why re-heater is used in gas turbine
What is the size of a Squre nut of a M12 Bolt
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)