Answer / rn

It can take radial and axial load.For taking axial load on
both sides it is used back to back position.

Answer / deshmukh rushikesh

It can Take Impact Load

What should you do before you start the engine?

3 Answers  

---

What is method to calculate the noise level at any point of duct if duct dimensions and air flow is known?

0 Answers  

---

What does a pump develops? Flow or Pressure. Give the Answer with Proper Logic.

3 Answers   DVC,

---

In a rankine cycle if maximum steam pressure is increased keeping steam temperature and condenser pressure same, what will happen to dryness fraction of steam after expansion ?

0 Answers  

---

describe a type when u anticipated potential problems and development of preventive measure.

0 Answers  

---

Is a diesel engines maximum rpm limited by the diesel burn rate?

0 Answers  

---

why is cast iron seasoning important before machining?

0 Answers  

---

my jindal interview is on 24th.. can anyone give me few tips regarding the same? lik how i shud prep

0 Answers  

---

where i can get APPSC AEE(Mechanical Engg) previuos question papaers

0 Answers   APPSC, Bhel, Tata Indicom,

---

what is the difference between type -a and type -b iron > The chemical compostion is given here under and also guide us the effect of Ni;Cr;Mo in the iron; name and use of these two types of iron Type a Type b %C :3.15 2.65 %Mn:0.41 0.52 %Si:1.72 1.60 %S :0.090 0.082 %P: 0.215 0.204 %Ni: 0.40 Traces %Cr : 0.49 Traces %Mo : Traces Traces

0 Answers  

---

What are the different type of mechanism to engage primary moving engine and transmission [ In other word how many different type of clutches are there

0 Answers   Ford,

---

What will be the cause of the loose compression in a cylinder?

3 Answers  

---