Answer / rakesh.r

He should have a proper quality to guide his/her employee. He
should have decision taking tendency and can control his team
& team members. He should have capacity to lead the team
according to circumstances

what is the difference between dross and scale?

1 Answers   Hindalco,

---

Given a cutaway isometric view of the steam turbine.

0 Answers   ABC Inc, RRB, Siemens,

---

I want to apply for Asst.vehicle inspector,i would like to know the requirements and the syllabus.. if any body know that please mai me.. naany4u@rediffmail.com please friends

0 Answers   APPSC, TN,

---

please send me model question papers for DVC Examination diploma mechanical

0 Answers  

---

why transformer required and why not voltage directly supply from power generation to the applications

3 Answers  

---

hallo I am looking for technical theortical knowledeg in air flow inside pipe and tunel's such as resisten of surefa's calculation and sempal's of calculation hopethat some budy can halp my thank you from devas

0 Answers   Uniparts Group,

---

What is the world is hardest metal?

0 Answers  

---

1.Difference between enthalpy & entropy?

3 Answers   Covanta Energy, TATA,

---

what is the calculation of selection ofan capacity is 12000m3/hr.

0 Answers   Engicon, Rana,

---

25 questions in 25 minutes were asked by L&T corein mechanical engg test on 28 nov 2011 are as follows:- L&t mechanical consists of 1> airfuel ratio 2> mollier chart for flow rate 3>homogeneous or hetreogeneous mixture 4>sublimation curve 5>effect on room temperature when fridge is opened 6>cop of refrigerator 7> punching and piercing uses shear or not 8>method not used for tapering 9>forming method not used for productn 10>numerical regardng no.of cuts 11>flow of chip is controlled by which parameters 12> property important for impact loading 13>stifness of spring when it is cut into 2 pieces 14> device reqd for energy fluctuation 15> property on which rivet is selected 16>crowning to prevent flat belt pulley errors like undercut 17>cavitation occurs at which stage 18>qstn regardng inventory control 19>for ship vessel industry what sort of plantlayout reqd 20>value engg definition 21> qstn on how the extnsn occurs for uniform loading 22> qstn regardng stress actng on the shaft23>maximum value of mohr's circle diameter 24>qstn regardng meshing of teeth 25>qstn on helical gear reqrd better read G.K.PUBLISHERS GATE PAPERS ESPECIALLY FROM 1993 to 2003 ESPECIALLY THEORY QUESTIONS RATHER THAN NUMERICAL QUESTIONS

0 Answers   L&T,

---

in a centrifugal pump .. when we close the delivery valve partially .. does this increase the pressure before or after the valve .. and why ??

1 Answers  

---

Mention two types of dislocations.

0 Answers  

---