How much should be the minimum and maximum suction and
discharge pressure of screw chiller plant.
No Answer is Posted For this Question
Be the First to Post Answer
Carnot cycle
2 Answers JKSSB, Tech Mahindra,
Explain knurling.
best tip to increase fuel efficiency with a high powered engine ?
what is a four stroke engine?
suppose that there is a gas turbine of 110MW having 3 stages, and compressor having 17 stages. what will happend when the stages of turbine increses to 6.
1.an you please send all INTERVIEW Unigraphics/ansys QUESTIONS&ANSWERS. structural analysis,linear,nonlinear analysis,modal,harmonic analysis all questions @answers? Send all typical HR questions &answers?
3 Answers Kennametal, Sandvik,
In Feature How use in distel water in use in bike.? 2) Above 2020 petrol prise 100 per/lit.? how can use in Poor people in Bike.
what's the difference between moment of inertia and mass moment of inertia?
Define a slined joint?
How cavitation can be eliminated by pump?
HYDROLICS
Metals, in general are of low strength and do not possess required physio-chemical and technological properties for a definite purpose. Alloys are therefore more than metals alone. Discuss the arrangement of atoms and structures of alloys.
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)