please suggest me, how can i change the display setting in term of unit in pla

please suggest me, how can i change the display setting in
term of unit in place of % of Honeywell pressure transmitter
ST3000S100?

Question Posted / om1111

2 Answers
4998 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

please suggest me, how can i change the display setting in term of unit in place of % of Honeywell..

Answer / u.prabhagaran

connect hart communicator,go to displa settings and then
change the unit.

Is This Answer Correct ?

2 Yes

0 No

please suggest me, how can i change the display setting in term of unit in place of % of Honeywell..

Answer / carl_ellis

The local Smart Meter option for Honeywell's ST3000 pressure transmitters can be set to show the PV out in engineering units that are appropriate for your process application; pressure or flow.

The linear or square root output is called output conformity or output form.

You can select an available engineering unit or enter a custom one including upper and lower display limit settings for the local smart meterâ€™s digital readout using buttons on the face of the meter.

Search the web for the ST3000 User Manual that covers local display configuration.

ST 3000 Smart Transmitter
Release 300 and Smart Field Communicator Model STS103
Userâ€™s Manual
34-ST-25-14 6/08

Carl Ellis

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.

0 Answers Essar,

WHAT IS SELF CLEAN ELCTRODE IN MAGNETIC FLOWMETER?? WHAT DO YOU MEAN BY THIS TERM??

2 Answers IOCL,

I want to measure level under vaccum by using DP Tx and vaccum vary between -500 to -670 mmHg and process fluid is accetic anhydride if consider process fluid density 1 kg/cm2. how to calibrate Tx ? consider level is 0 to 100 Cm.

1 Answers CCC,

is motorized valve closed when power shutoff?

0 Answers Unilever,

In apron feeder how TPH is calculated?

0 Answers Lafarge,

What is solenoid valve? Where it is used?

0 Answers

What is the standard height for stancion supports? and what is the standard mounting height for different transmitters?

11 Answers Samsung,

what do you know about Foundation Fieldbus?

1 Answers CCIE,

what is wave length were using ?

0 Answers

when an eddy current probe is installed inside of a turbine or compressor in case of probe problem same as:crash of head of probe,changing the scale factor because of low measuring gap(physical gap is ok(example=1.14mm)but voltage is reduced(example=-6 volts),is any way to check the probe,when the ohm of probe is ok.thank you,(Karim Tavakoli)

1 Answers

how to calibrate corollaries (Mass flow meter)?

0 Answers Honeywell,

what r the different types of instrumentation cables? give their specification?

3 Answers

For more Instrumentation Interview Questions Click Here